Purge Blocks actually serve more than one purpose. Do you know what they do?
You've seen them used a few times over the past year, but what are Fabricated Tube Mounts and how do you make them?
See how a simple fabrication mod can save you money when you change your mind midway through a build!
A necessary sub-frame and steering rack modification for 20b and 26B Rotary Engine Swaps in the FD3S Chassis.
Round two of the completely hand built Sheet Metal Intake Manifold. What two challenges remain to be solved? Find out here!
Building a custom spec Sheet Metal Intake Manifold is challenging enough by itself, but there is one catch with building this one....
When your classic Buick is slammed to floor with a set of bags, you tend to run into issues with the gas tank scraping. Filling the trunk with air ride equipment takes a lot of space as well - so what do you do? How about fabricating a fuel cell to fit in the spare tire well...?
What What would you do if you found out your limitless build had no space for any kind of conventional radiator? What if you had to design something unconventional to cool down an engine that can't be replaced easily? What would you come up with?
Part 1 of a 4 part How-To series demonstrating how to narrow a Ford Explorer 8.8 Rear Axle. This is a quick reference prelude section with common questions and answers as well as all the info you need to help make your selection.
What very simple trunk design took the trophy in the Hottest Trunk category at HIN Las Vegas 2015? Check this out....